     Kermit-10 now has a lot of patches put into it.  The first set of
patches  is  based on those submitted by PIMA.  The subsequent patches
are added in order to make Kermit-10 similar to Kermit-32.   The  last
patch  is to change all the search file names to K10???  as opposed to
KER???.

1.0

PATCH [127]

     Based on the patches we received from PIMA the following  changes
have been added to KERMIT and KERUNV.


     1.  Fix IFN stopcode if syntax error in KERMIT.INI.

     2.  Add help text for connect mode ESCape commands.  Q (Quit) and
         R (Resume) logging

     3.  Add SET XON-XOFF-PROCESSING to determine how Xon/Xoff  should
         be handled during connect.

     4.  Add a new File Byte Size of 36-Bits for 10/20 transfers

     These changes are in Modules KERMIT and KERUNV
                                                                Page 2

2.0  

PATCH [130] & [3.1.045]

     When attempting to do multiple file  sends  from  Kermit-10,  the
prompt indicating subsequent sends is screwed up.  It sends:  the sent
file name, followed by, "as ", "Sending:  ", and  then,  the  original
file  name.   This  is  due to the timing of when NEXT_FILE prints the
"Sending:  " prompt.  The fix is to take the subsequent  file  sending
prompt  out of KERMSG and put it into KERMIT.  This fixes the problem,
but it also requires a similar patch to  be  put  into  KERMIT-32  and
PROKERMIT.

     Changes were to Modules KERMIT and KERMSG.

3.0  

PATCH [131], [132], & [133]

     Make KERMIT-10 look similar to KERMIT-32.  Alow KERMIT to set the
IBM handshaking character, incase the IBM character is something other
than ^Q.  Fix the IBM macro defined to set  up  the  three  parameters
required  for  IBM  transfers, this means to add in the setting of the
handshake character.  The kludge use of IBM-MODE is no longer  needed,
remove it.

     The changes are in Module KERMIT
                                                                Page 3

4.0  

PATCH [134]

     Since  the  distribution  files  for  KERMIT-10  are  changed  to
K10???.???,  lets  make the source file names that in the first place.
This requires that all search file names must be  changed  to  K10???.
The  prologue  in  K10UNV should remain as KERMIT or else you won't be
able to find the help file for KERMIT.  Also there is a new help  file
which  contains  the  SET  HANDSHAKE and SET XON-XOFF-PROCESSING help.
The help file also modifies the the SET IBM-MODE command  to  SET  IBM
which initiates the IBM macro.

     These changes were done to ALL Modules.
   